AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter · #1 ·
I am preparing a wall for eventual mounting of a 503 cmx. Assuming the Plasma is on the wall, where do the video and power cables come into the unit? Left or right? Top or Bottom?


I am trying to figure out where to put the power and holes for cablesfor a flat wall mount.


Thanks
 

·
Registered
Joined
·
282 Posts
As you are facing the acrylic screen, the power cord is on the bottom left, about 5 inches from the left end. The various inputs are all along the bottom. The 5002 card is inserted bottom, left of center.
 

·
Registered
Joined
·
282 Posts
You have 4 inches from the bottom of the 503 then it comes flush with the wall ie 1/2" -- so you need to make your hole in this 4 inch area -- I made my hole 11.5 inches from the left corner (if you are facing the plasma) and started the hole 2.5 inches up from bottom.


I found it very helpful to use a cardboard template of the display - hung that on wall first and then worked from there


Michael
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top