AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
18 Posts
Discussion Starter · #1 ·
Sorry for posting always similar questions, but i'm setting up my marquee 8500 and want be sure doing right the final calibration.


I setted h-size at 90, running 1024 x 768 at 75hz.


The image is well centered on the tube's face and correctly distanced by the edges but the raster (larger than image) is larger than tube's surface and goes beyond the tube's edges.


I read h-size must be setted between 85 end 95, so i could be right but i'm worried by widht of the raster; don't want to risk tubes' failure.


Thanks a lot. Aurelio
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top