AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
330 Posts
Discussion Starter · #1 ·
I have a RCA DTC-100 and just bought a new Harman Kardon AVR 210. When I change channels on my DTC-100 to a Dolby Digital channel it detects it and switches over, but when I go back to a normal channel instead of switching over back where I had it set (Pro Logic) it switches over to no surround. Is there a way to save my settings so when i swtich back and forth from Dolby Digital to analog it would switch to Pro Logic? Also if I cannot save the settings is this problem only with Harman Kardon receivers? I am only using the optical connections and have it setup to "video 1". Thanks!


-Troy
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top