AVS Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
1,505 Posts
Discussion Starter · #1 ·
I have programed my RCAP05B setup button for my Yamaha RX-V465 AVR


I have just the setup the AVR will display speaker however I can't change any value w/ the direction button.


I want to be able to set the speakers up example large small none phantomcenter ect.


any tips is appreciated.


STB
 

·
Registered
Joined
·
15,338 Posts
Please continue this line of questioning in your original thread HERE where all the answers have already been posted.


But I have to ask why you continue to use the RCA if you have at least two Harmonys? Couldn't you learn the commands in question from Harmony?
 

·
Registered
Joined
·
1,505 Posts
Discussion Starter · #3 ·
Hello Dave this other old thread was only to turn on and off the AVR.


Current problem is unrelated. here's a link.


I'm planning on getting a center channel speaker and will need to be able to turn it on it's currently set to off when I had the 300 w/ my harmony software I was able to adjust speakers not the case w/ this RCA or the 700.


http://www.avsforum.com/avs-vb/showthread.php?t=1333327


Thanks
 

·
Registered
Joined
·
1,505 Posts
Discussion Starter · #4 ·
Hello Dave I resolved my speaker setup adjusting values.


I accidently found a soft enter button on my 700. the soft button works and the

OK button inbetween the directional buttons no work.


I may mess around w/ customize buttons advanced however I'm leary of too many reflashes, this remote is now locking up on help only reamedy is to remove the batterys.


then I believe the update doe'snt get saved correctly.
 
1 - 4 of 4 Posts
Top