AVS Forum banner
1 - 3 of 3 Posts

·
Registered
Venu360, Niles power Amp, Emotiva power Amps, Crown power Amps, Yamaha CX-A5100, DIY speakers, UHZ65
Joined
·
596 Posts
Discussion Starter · #1 ·
I have searched the forum and maybe I can not put the right key words in.


I would like to remote control in a multi-amp HT my old Denon. I can't tell from the documentation if I can just feed a 12v trigger into the remote In jack on the back to turn on the AVR.


Before doing something not smart does anyone have the specification on this connector?
 

·
Registered
Venu360, Niles power Amp, Emotiva power Amps, Crown power Amps, Yamaha CX-A5100, DIY speakers, UHZ65
Joined
·
596 Posts
Discussion Starter · #3 ·



The jacks below are output only.....The remote in doesn't say IR and in the picture it comes from an IR receiver I believe (RC-616) however difficult to tell.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top