AVS Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Has anyone had any luck connecting their DishPVR 508 to a ReplayTV? The reason this seems to be problematic is that the DishPVR 508 uses UHF for channel changing. It may also support IR channel changing(it supports IR for power on power off opperations) however, if it does, I haven't been able to figure out the compatible codes.


Has anyone had success getting the two to work together? What codes are you using?


I have a Replaytv 2000.
 

·
Registered
Joined
·
334 Posts
I believe Replay works with all Dish receivers as long as they are setup with remote code 1.

I have a 501 and it supports both IR and UHF. I currently don't have it connected to the Replay because I use it as a separate DVR ( I have my Dish6000 connected to the Replay).
 

·
Registered
Joined
·
93 Posts
My Replay boxes have no problem changing the channels on Dish receivers

(including a 501, which is a 508 with a smaller hard drive). I use the IR blaster,

and I think the code I've used during the Replay setup is 775 to identify the

Dish box.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top