AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
498 Posts
Discussion Starter · #1 ·
I have the possibility to use either RGB+HV or a Component Pb/Pr from my Muse decoder. Which would be the best option if connected to the LT150? The cable needs to be at least 10m (33").


------------------

BR /// Rob
 

·
Registered
Joined
·
733 Posts
Assuming you're referring to HDTV then -


The beauty of component is that you retain control over aspect ratio (so you could user the panamorph) and also colour, tint and even a choice between HDTV and SDTV clour selection. For HDTV reports on this forum indicate that you will obtain a more stable image with component.


Cheers,


Grant
 

·
Registered
Joined
·
498 Posts
Discussion Starter · #3 ·
Thanks Grant for the answer1 Yes I was referring to 1080i. I did some reading and found out that one a component signal is less sensible for distortion. One of the reason was that the green is not transmitted, but re calculated at the far end (Y-R-B=G). As green normally only is 11 percent of the total. Due to this it is more sensible for interference. Also the fact that I have to pay for two less cables/connectors makes it an easy choice for me.


------------------

BR /// Rob
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top