AVS Forum banner

Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
83 Posts
Discussion Starter #1
I want to purchase this amp but i am only going to use 2 channels for the time being. Can i bridge this amp to get more power to the 2 channels im going to use? If so how would this be done?


Thanks
 

·
Registered
Joined
·
73 Posts
You connect an Y-cable (typically used for subs) to two inputs of the 1075. Then you connect two sets of speaker wires from the corresponding outputs, one to each of the biwire terminals on your speaker. Make sure to remove the bridge that connects the terminals first.
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top