AVS Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1
I have replaced the system board in my Runco IDP900 and entered several aspect ratios into the signal input list. However when I use the Runco NON-wired remote and push IDTV1, IDTV2 etc. those don't change the input to any that I have progammed. How do I map the input buttons on the remote to the actual signal input positinos in the projector? Thanks.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top