AVS Forum banner

Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
348 Posts
Discussion Starter #1
I finally got around to running my Belden 1694A component video cable through the wall and ceiling, back to my ceiling-mounted X1. It would be convenient to use the same hole in my ceiling to pass both the video cable and the X1's power cord through. I'm a bit concerned about doing this because of the potential for interference from the power cord. The video and power cords would run side by side for about 4 feet. Any advice? Am I worrying about nothing?
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top