AVS Forum banner
1 - 2 of 2 Posts

6 Posts
Discussion Starter · #1 ·

i recently purchased a 4081 display and i had to make a change to the "panel option" setting in the service menu after upgrading the firmware.

unfortunately, due to my unfamiliarity with the lag-time of the user interface of the service menu, i think i may have changed one or two other settings by accident.

i am not positive that i made any changes outside of the "panel option" setting, but i am kindly asking other owners of the 4081 to share their DEFAULT settings from the "option byte" of the service menu.

the reason for asking is that after upgrading the firmware from 1003 to 1008.3, suddenly the display is no longer able to find a signal via the over-the-air input. previously, it was able to find a signal, although, it was not a perfectly clean signal.

any thoughts?

thanks in advance.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.