AVS Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
43 Posts
Discussion Starter · #1 ·
Here is what happened. I had my TV hooked up to my cable box via components. I had a nice full screen when watching SD channels. I then decide to see what this HDMI fuss is all about.


I hooked it up from the DVI out on my box with a HDMI/DVI adapter. I decide component has much much better blacks so i go to hook them back up.


Now my SD is either one small square in the middle or it has two big black bars on the sides. Also where as before i was getting 480i/480p/720p on my info screen i now only get 720p. Im assuming my box has gone in to limp mode. Is there anyway to reset it, i have tried unplugging both the TV and box.


Any suggestions?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top