AVS Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·

Recently purchased from Costco, it replaced my Sharp 60". I'm hoping I could get some info on calibrating it, as well as some info on programming the remote.

 

Calibration setting anyone?

 

As far as the remote, is it possible to program it to adjust the volume on my Bose Cinemate speaker system? I'm currently having to use the Samsung remote, as well as the Bose. The TV came with an "IR Balster", but I couldn't seem to figure that out.
 

·
Registered
Joined
·
8 Posts

These are the calibration settings I'm currently using. Pulled them out of the 6400 thread with a couple tweaks for my personal taste.

 
Picture ModeMovie
Backlight16
Contrast95
Brightness37
Sharpness13
Color50
TintG50/R50
    
ADVANCE SETTINGS
Dynamic ContrastOff
Black ToneOff
Flesh Tone0
RGB Only ModeOff
Color SpaceAuto
White BalanceSee below

10pt White Balance
On
Gamma-1
Expert PatternOff
[TD] [/TD]
 
PICTURE OPTIONS
Color ToneCool (whites aren't yellowed)
Digital Noise FilterOff
MPEG Noise FilterOff
HDMI Black LevelNormal(Low if available)
Film ModeOff
Auto Motion PlusOff
LED Motion PlusOff
WHITE BALANCE
SettingValue
R-Offset25
G-Offset25
B-Offset27
R-Gain19
G-Gain22
B-Gain21
10PT WHITE BALANCEON
IntervalRedGreenBlue
1010
210-2
3002
4000
5-10+1
60-10
7-1-2-2
8021
9100
10210
 
SCREEN ADJUSTMENT
Picture SizeScreen Fit

 
 

Hope they work well for you.

 

For the remote go to MENU | SYSTEM | DEVICE MANAGER | UNIVERSAL REMOTE SETUP

 

Good luck
 
1 - 2 of 2 Posts
Top