AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
48 Posts
Discussion Starter · #1 ·
I installed my Sat C kit yesterday. I have two HD receivers. All was fine on the Hughes, got 543, etc. On the RCA DTC-100, the only way I can get 543 is to put the Hughes on 543. But when this happens, all even numbered transponders on the DTC-100 go off. I exchanged the "out-to receivers" cables on the multiswitch but it did not help. Here is something else that is crazy. I disconnected the satellite cable to the DTC-100 for a few second, re-connected and it worked fine, got 543, etc. But when I changed channels on the Hughes, the DTC-100 went back to not receiving 543 unless I put the Hughes on 543 and again the channels from even numbered transponders gave a "searching for satellite" message. Could I have a bad multi-switch? Any HELP would be appreciated. Thanks.


Jim
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top