AVS Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
64 Posts
Discussion Starter · #1 ·
I mounted a 144" BD Zero Edge 2.35:1 screen today and everything went really well except the bottom right hand corner of the screen is pushed out from the wall about 1/2-1". All the other corners and areas are flush to the wall. Obviously, the image is distorted a little in that corner.


There were 3 brackets in the hardware box so even thought it only called for 2 I used the extra bracket in the middle for a little extra support.


The installed screen is level along the top edge, verified.


Any ideas on what could be causing this? Only thing I can think of is that the wall isn't flat but I think it is and I can't find any other points on the wall that are off using my long level (4-5ft).


If I can't figure it out, I think I'm just going to stick it to the wall in that area using an adhesive. Any suggestions?


Thanks.

-john
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top