AVS Forum banner
1 - 1 of 1 Posts

604 Posts
Discussion Starter · #1 ·
Red, green and blue images don't line up perfectly. I need to do a convergence.

Do I need the service or factory manual to do it "right"?

Only info I have so far is to press SELECT and INPUT on the projector to enter FACTORY mode, and adjust items 7, 8, 9, 15, 16 and 17.

Do I press SELECT and INPUT simultaneously?

Do I need to adjust these items for each type of input (component, DVI, etc.)?

How do I navigate in the factory menu?

1 - 1 of 1 Posts