[CHUCK GIGLIO]

hello,

i have three snell #550 passive subs the left and right are powered by a parasound 1500a amp 205 watts per channel the rear is hooked to a 1000a amp 110 watts per channel that is bridged to 300 mono,i also have a parasound avc2500 that has auto cal. mic that can set the input level and delay.should i run all three subs from the avc2500 and use the auto cal. mic or should i run the rear sub through my paradimg x50 sub controler so i can use the phase control?

thanks for your help

 

[TV]



I'd put all three enclosures as close together as possible in the optimal location in your room. Try a corner nearest the key seats,preferably a corner with no adjacent openings nearby. You shouldn't need the phase control...if you want you could just switch *polarity* on the sub drivers to wire them 180 degree *out*. Just be sure to do all three the same way--if they are near one another. Also, be sure to turn the amps off before you do this(of course).



TV

 

[Rachael Bellomy]

Have you considered using one of the subs for the rear channels? Then you could pick large for them and have discreet rear bass.I'm planning on doing this when I move to a bigger place...I'm not sure what's good in rear placement,as I have not done this, but I assume a rear corner...just a thought.


------------------


Ms. Bitchlist