AVS Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I have a Mitsubishi DLP with an Onkyo receiver. I'm trying to set up my Xbox 360 to use component over HDMI. Right now I have my Xbox hooked up through the Component IN1 slot. I want to use it on the input of Video 2, so I went into the Video Input menu and under the Component section I set Video 2 to IN1. From there I don't know where to go, all the manual says is that it supports Component over HDMI, but doesn't say how to set it up.

I am pretty new at this stuff so any advice would help.


I have figured out the issues I ran into.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.