AVS Forum banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
111 Posts
Discussion Starter · #1 ·
Sharp 9000 + Faroudja NR - I am in the midst of purchasing this combo and am trying to determine what cables I need for the set up. For those who own it, what cables do you run between the two units -- RGB, RGBS, or RGBHV (I assume BNC on NR side, RCA on Sharp...)?


Thanks

Jeff


[This message has been edited by Jeff Owen (edited 10-05-2001).]
 

·
Registered
Joined
·
364 Posts
I run a 40 feet Straight Wire Silver Link II 5xBNC-RCA cable from NRS to z9000, and the picture is fabalous (even though the cost is very high ! about 1k)


Cam
 

·
Registered
Joined
·
529 Posts
Jeff- I ran a 35 foot BetterCables Silver Serpent 5 wire RGBHV cable (BNC's NRS end, RCA's 9000Z end) and the cost was $324. Construction and quality is very high, and once my 9000Z and NRS arrive I can report on picture quality.
 

·
Registered
Joined
·
639 Posts
i talked to sharp techs and bettercable guys and its a tossup of 15 pin vga or rca connectors. they should both produce same results, they said. rca's should be a better physical connection i would think. vga to bnc is cheaper.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top