AVS Forum banner

Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Hi all.


I've recently puchased a Sharp 9000U and Faroudja NRS 16:9. I've tried to experiment stand-alone setup (using on-board scaler) vs 9000U scaler by-pass using NRS via input 5. One thing I noticed is that the image/picture quality without the NRS seems to be a heck of a lot better than with the NRS connected. This can't be right. Does anybody/anyone know if there is a "baseline" configuration for this pair prior to doing calibration tweaks?, Also, any cabling issues i.e. NRS RGB out -> Sharp 9000U DB15 port.


TIA.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top