AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

· Registered
Joined
·
581 Posts
Discussion Starter · #1 ·
Dear all


I was wondering. Does a Sharp 9000+Grayhawk combo make any sense ?

The new Sharp is rated:

800 ANSI Lumen; (600 Theater Mode)

If I wanted to use Theatermode (quieter!), wouldn't the 600 ANSI be to dim for the Grayhawk ?

Based on the specs of the Sharp, what 16:9 screen would you go for (in a lightcontroled room)?


Thanks


Anthony
 

· Registered
Joined
·
81 Posts
I'm wondering the same thing. If it is a good match would it still be acceptable with a minimum amount of daylight creeping through drawn shades and curtains? If not is there an alternative recommendation?
 

· Registered
Joined
·
12,276 Posts
As no one has really seen the Sharp unit yet, it's hard to say. I can tell you that the screen size you decide to go with is going to make a difference. I have seen the Seleco HT200DM, a 650 lumen unit, on a Grayhawk and it looked great. It was also not that large a screen and the room was pitch black, though.


Thanks!


------------------

Jason Turk

AV Science, Inc.
http://www.avscience.com

716-454-1460 ext.204

[email protected]
 

· Registered
Joined
·
581 Posts
Discussion Starter · #4 ·
Dear Jason


Are the 650 ANSI for the full 800x600 panel or is this number valid for the 480P mode ?

If I wanted to use a 2.3m (picture)wide screen, would the

lightoutput be enough on a Grayhawk or should I go for a smaller width (2m)?

Obviously if you saw the Seleco HT200Dm with a Panamorph then my question above would be answered.


Cheers


Anthony
 
1 - 4 of 4 Posts
Status
Not open for further replies.
Top