AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

· Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Does anyone/anybody know if the on-board scaler on the XV-9000u can be disabled? I've recently ordered the Sharp XV-9000u and Faroudja NRS 16:9 scaler and I'm concerned that I might not be able to use the Faroudja with the Sharp. Also, any suggestion(s) as to what cable I should use for interconnecting the Sharp projector to a scaler? BNC-BNC, BNC-RCA, BNC-VGA? TIA. [email protected]
 

· Registered
Joined
·
77 Posts
Yes & No.


The on-board scalar on the XV-9000u can be disabled depending on the firmware. Models made (Sharp XV-9000u) after Dec 1, 2001 should have a fix for this in the firmware. You should connect the Faroudja NRS through the RGB connector. Do a search; there is a lot of info on this subject.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top