AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
1,323 Posts
Discussion Starter · #1 ·
I dabbled into installing projectors last year, and I am having trouble with a customer's install. I can only relate the symptoms he has reported to me over the phone. He has a Sharp XV-Z9000, and he runs it an average of about 6 hours a day. It went through its first lamp at this rate in only 900 hours. Last week he calls me and says the PJ began turning itself off and on, until it just shut down and locked up. He replaced the lamp, thinking the bulb to be the problem again, but it is still locked up. The lamp counter was properly reset, so I don' think it reading over 2000 hours is the issue.


According to him, no warning lights are on, the standby lights are on as normal.... the PJ just will not fire up. Any ideas?



Andrew
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top