AVS Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
332 Posts
Discussion Starter · #1 ·
I've been doing a bit of research on powering a whole bunch of subwoofers since working out how many drivers I need in this thread .


From what I understand, 'bus pumping', is a real issue with Class D amps (those designed as half bridged) when delivering a lot of power. It seems the only way around this is to bridge the amp.


Are all class D amps designed as half bridged? How do I know a full bridged design? Where do I find this information? And, finally, why is it that bridged Class D designs are often *not* 4X the 8 Ohm power?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top