AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 ·
I looked all over the manual but can't find the type/size of screw my BenQ PE7800 projector allows me to use to hang it up-side-down.


Can anyone tell me? :)
 

·
Registered
Joined
·
200 Posts
I had a similar problem with my Infocus 4805. I just took it into Lowe's with me to match up the screws.


Don't forget to check metric sizes -- they are often in a separate section.
 

·
Registered
Joined
·
104 Posts
I have a BenQ 6100 and had a real hard time finding the right bolts to mount the projector. I eventually took it down to Home Depot and tried MANY bolts in the bolt isle. I eventually found one that fit called 4M, unfortunately it was only 3/4 of an inch long and I needed more like 3 to 4 inches. I ended up ordering the right bolt from Calgary Fasteners a processional nut and bolt shop. They had to custom order them and were about $3 if I recall.


I am not sure about your model, but I suspect they may be the same.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top