AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter · #1 ·
i just buy a skyworth and i didnt know if its possible to change contrast, brightness ... on this units ?


i have a sony 1271 and found the picture too dark !


any idea ?


thanks


Nicho
 

·
Registered
Joined
·
784 Posts
Using the Skyworth to drive the RGB inputs on the Sony, you have control of Black Level (BRT) and White Level (CNTR) on the projector remote.


For best results, use a setup disc, such as Avia or Video Essentials to adjust Black Level(BRT). Adjust White level (CNTR) to get the overall brightness you want. The two adjustments interact slightly.
 

·
Premium Member
Joined
·
4,957 Posts
I just posted a note in the DVD Hardware section about messing with the output DAC on the Skyworth. I hooked a scope up to the output and looked at Avia's vertical gray bars. The 100IRE bar was just a tad under 0.7V so it certainly *should* be bright enough. However, I mentioned how you could bump the output to 1Vpp if you wanted to (plenty bright).


Cary
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top