AVS Forum banner
Status
Not open for further replies.
1 - 4 of 4 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
When i hooked them up using the Skyworth vga output thru vga breakout cable w/adaptor and 5 separate cables instead of the normal pro. scan component output (3 cables), no image at all.


What's wrong ? What are the correct settings for the Skyworth and the 10HT ? or my vga breakout cable faulty ?



cheers
 

·
AVS Forum Special Member
Joined
·
11,139 Posts
My RPTV has separate input menu selections for VGA and 3-wire component. You've set the DVD source and I trust you've set the projector, too.


Before I hooked up my computer to a monitor with a VGA/5-wire cable I checked the manual for my video card, which lists the pin connections, and matched them to the monitor connections (5 BNC connectors). As a double check, I measured the VGA-plug cable pins to the 5 breakout cables with an ohmmeter to check continuity. -- John
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Status
Not open for further replies.
Top