AVS Forum banner
Status
Not open for further replies.
1 - 6 of 6 Posts

·
Registered
Joined
·
120 Posts
Discussion Starter · #1 ·
Hi.


I have a Sony 1270QM that is working great but every time I start the crt I need to realign the red and blue. Its not much but its enough to be noticeble. When I have realign them it holds its position until the crt has been turned off.


Does anyone have any ideas why this is ?


TIA

Bjonne
 

·
Registered
Joined
·
41 Posts
I don't have an answer for it, in fact i have the same problem and the same PJ.


I think i've used the zone convergeance too much and therefore the image keeps shifting. I did notice that after properly warming up (running a movie for an hour or so) the red and blue sometimes shift back to the original position.
 

·
Registered
Joined
·
448 Posts
Are you pressing the memory after you do the setup?
 

·
Registered
Joined
·
9,398 Posts
I believe there is a memory battery that holds setup info. It must have gone bad.
 

·
Registered
Joined
·
8,079 Posts
I had a 1251 that either took ages to warm up and then the colours would line up, or sometimes they never would.


Your PJ is just old. Something could be replaced I guess, but I don't know where to start looking.
 
1 - 6 of 6 Posts
Status
Not open for further replies.
Top