AVS Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
I'm new at this and I am having problems with my 1270. It used to be OK until a few nights ago and this is what happened. It powers off whenever i turn on my video source. I tried to turn on the source first before the projector, it doesnt shut down anymore but the convergence is off. I pulled the composite video in and put it again, the convergence becomes OK but after 2 seconds, its off again. What could be wrong with my CRT? Pleasseee Help...

:confused:
 

·
Registered
Joined
·
164 Posts
well its not converged when its not connected because you converged with a source..


i think your supposed to converge without a source first then copy that to all the memory locations.

then you do individual convergance for different sources.


as for the powering off i have no idea.

-eric
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #3 ·
Thanks for your reply. Whenever I turn on my projector, the message that says wait for 20 mins is converged but after that incident, even that is not converged anymore. What could have hapened? If i pull video cable then place it back, the convergence is OK for a few seconds then its not again...
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top