AVS Forum banner
1 - 14 of 14 Posts

· Registered
Joined
·
18,489 Posts
I don't have spare boards, sorry, but can repair yours.


Actually, I can swap you a repaired one to save time, but I need yours back..
 

· Registered
Joined
·
870 Posts

Quote:
Originally Posted by Curt Palme /forum/post/18193436


I don't have spare boards, sorry, but can repair yours.


Actually, I can swap you a repaired one to save time, but I need yours back..

Curt, is that the board on the G70 that you upgrade for longevity?


craigr
 

· Registered
Joined
·
18,489 Posts
Yes it is.
 

· Registered
Joined
·
870 Posts

Quote:
Originally Posted by Curt Palme /forum/post/18196181


Yes it is.

Well, if I had a G70, I would send you my board for the upgrade even if it still worked. The DC seems to go out frequently on the G70. It may even be the most common failure.


craigr
 

· Registered
Joined
·
18,489 Posts
$275 USD incl. shipping. I'm shipping again on friday.
 

· Registered
Joined
·
13 Posts
Discussion Starter · #11 ·
just back from bali that was the worst heat I have experienced in going there for 6 years ..... the problem Jacarts had bucket of rain and it carried down to Bali every morning , then it became a steam bath .


or back to the board

can you send me your bank details to [email protected]

at the return I will get your post detail and you can have mine .


I Take it the mods are done on this board as this is the secong one replaced they go about every 1-2 Years


bit of a pain


Bob
 

· Registered
Joined
·
18,489 Posts
Email sent, thanks!
 

· Registered
Joined
·
1,866 Posts
BTW- Curt repaired my G70 DC board, and it's worked like a charm since the minute I plugged it in.


Forget about buying a used DC board, as I tried that, and the darn thing would only run for a few minutes before screwing up, even though it came out of a very low-hours unit.


Curt does all the right mods to make it last.
 
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top