AVS Forum banner
1 - 1 of 1 Posts

· Registered
27 Posts
Discussion Starter · #1 ·
I just finished replacing the two IC chips (due to no power; 6 blinking lights). During the process, I discovered that white wire from the flyback transformer on the D-Board going to the small board at the end of the tube was hanging loose. It looks like the metal pins hav broken off completely from the "tube" board. The big problem is that there is no way to solder the connector to the board.

The white wire is actually a single wire (not dual). The connector clamps down on the wire and splits it into a two-pin connector. The two pins are then soldered to the board.

...... /----- O

...... \\----- O

Now I get 3 blinking lights when powered on. It stops after 3-blinks, and then shuts down.

Is there any way to salvage this mess? Thanks.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.