AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
Help!

I just bought a Sony BDP S-590 blu ray player and its hooked up to a new Epson HD 710 projector via a new Sony STRDH520 7.1 Channel 3D AV Receiver. I set the blu ray to match the projector resolution (720p) but when I use the home page menu to access Netflix for instance, it does fine, but then drops the signal for no apparent reason and I get a blue screen. If I power down the A/V receiver, and then power up again, the home menu will display, i will be browsing netflix for a few minutes and it drops out again.


This is not an issue (Dropping signal) whenever I am playing a disk or using the cable box for TV.


Anyone have any thoughts on whats going on here????
 

·
Registered
Joined
·
2,807 Posts
There is a official thread for the 390 and 590. Post your question there.


Try setting the HDMI output to "auto" rather than 720p. Try turning off Deep color.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top