AVS Forum banner

1 - 3 of 3 Posts

9 Posts
Discussion Starter · #1 ·

I am using a Marantz SR5007 for my HT setup and recently wired my house for distributed audio. However, the separate amplifier (Crown XLS1500) I have for that does not offer remote volume control (something desired) when I use the preouts (fixed at -40.0 dB).


I was wondering if I could use the powered zone 2 posts to my amplifier in order to gain remote volume control through the app or if this is detrimental to the amplifier and/or receiver.


Alternatively, I know I could install some wall plates to do volume control. I would use the monoprice volume controls if I went that route, but would prefer to just use the powered receiver output if it is appropriate to.


Thanks for your input!
1 - 3 of 3 Posts