AVS Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
Hello,


I just hooked up my 50" ST30 to my laptop (a dell 1737 strudio) and it is fine at 720 resolution.. However, when it becomes higher (1920x1080) the sides get cut off on the TV...its strange because that is the recommended setting.. i tried playing with the monitor refresh rates, and that did not solve the problem...I tried googling it and searching, but it was to no avail.


Is there anyway i can test if the ST30 outputs in 1080p? Is there a button i needed to press that i'm missing?


thank you!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top