AVS Forum banner
Cancel
  • Take part in a short activity and share your valuable opinion on new design concepts for AVSForum! >>> Click Here
  • Our native mobile app has a new name: Fora Communities. Learn more.

Stewart screen problem

282 Views 2 Replies 3 Participants Last post by  Dan Henderson, 
B
I just received my new Stewart Luxus A Electriscreen.


I was disappointed to see that the power/control cable for the unit is truncated bare wires (no plug, etc). I naively thought that I could just hang it up, plug it in and go. I guess I need to buy a power cable and splice the wires or something? Any tips/info?


Thanks,

Bryan
Save
Like
Status
Not open for further replies.
1 - 3 of 3 Posts
B
Bryan,


Why don't you contact the manufacturer and ask them what procedure to use? Don Stewart comes to this forum from time to time but you'd be better served if you used proper channels and contacted customer service. Good luck with your new screen.
Save
Like
D
Bryan,


I'm sure that over 90% of the screens that Stewart sells are not installed by the customer. We usually have to extend the wire that Stewart gives us to plug the motorized screens in, so we always expect to have the proper parts on hand.


To answer your question, yes, you will just need to goto Home Depot and buy a 110v 2 (or 3?) prong plug. Sometimes we run the power pretty far so that we can switch it on with the receiver or projector. (When a 12v ground is not availible)


Dan


------------------
Dan Henderson
[email protected]
See less See more
Save
Like
1 - 3 of 3 Posts
Status
Not open for further replies.
AVS Forum
A forum community dedicated to home theater owners and enthusiasts. Come join the discussion about home audio/video, TVs, projectors, screens, receivers, speakers, projects, DIY’s, product reviews, accessories, classifieds, and more!
Full Forum Listing
Explore Our Forums
Receivers, Amps, and Processors LCD Flat Panel Displays Speakers HDTV Programming Home Theater Computers
Top