AVS Forum banner
Status
Not open for further replies.
1 - 2 of 2 Posts

·
Registered
Joined
·
527 Posts
Discussion Starter · #1 ·
Hi there,


I just added the SAT-HD100 as a second receiver to my SAT-A50. I added a single LNB dish to get 119 programming. The cable from the single LNB dish and one of the cables from the dual LNB dish pointing at 101 are connected to a 22kHz switch, then to the HD100. The remaining cable from the dual LNB dish goes to the SAT-A50.


If I power on the A50, my signal strength on 119 (on the HD100) goes from 50 to 0. I can't tune in any HD sat. stations.


Anybody know why this is happening?



Thanks,


David
 

·
Registered
Joined
·
24 Posts
your wiring protocol is o.k.


seems that you have the 1st or 2nd generation dish of Sony with dual lnb


with the "red blinking LED for lock verification"


I've heard that some people have experience problems with theese old dishes combined with newer receivers.


may be somebody else on that forum will come up with more info.
 
1 - 2 of 2 Posts
Status
Not open for further replies.
Top