AVS Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
35 Posts
Discussion Starter #1
Recently, I have been geeting strange garbled audio problems on my DST3000. This only started happening recently (last couple of days), and only happens on analog OTA signals. The reason I suspect the DST3000 is that I can go into the menu / setup page (where the signal strength meter is located), and then go back to the original analog OTA channel, and the sound clears up. This will stay cleared up until I change to a digital OTA channel, then back to any analog OTA. Then the sound gets garbled again. Anyone experience this before, or have any suggestions?

 

·
Registered
Joined
·
35 Posts
Discussion Starter #2
This problem was fixed by unplugging the DST3000, and letting it go through the Prog guide download, and OTA re scan. Don't know why.

Glenn
 

·
Premium Member
Joined
·
11,837 Posts
Static build up is one possibility even if it is grounded.


------------------

Kipp


IS THAT A REMOTE CONTROL IN YOUR POCKET OR ARE YOU JUST HAPPY TO SEE HDTV?
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top