AVS Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
722 Posts
Discussion Starter #1
Ok, just recieved my RTI8's, well being new to the whole audio thing, do i need to run 2 wires out of my Onk 705 fronts and plug one to the top and one to the bottom connections of the speaker or do i just need to connect the top connections. This is new to me so any help is appreciated.


Back of speaker has connections like this, do i need to plug into the top or both???


+ -

+ -



If both how do i run it out of my Onk 705??


Thanks
 

·
Registered
Joined
·
1,121 Posts
search on this topic. opinions vary.


if you choose to bi-wire just run two speaker wires out of your amp to the speaker (example. front left would be two speaker wires 2 + 2 - in same terminal split at speaker) if you choose not to then more often it is connected to the top terminals but check your manual.


i went with just 1, my friend went with two.??


he says there is a difference, and i said he was nuts.




just for fun i did bet him that i would wire one speaker single, and the other bi-wire, and if he could tell me what which was bi-wire i would buy him lunch.


long story short i had a free lunch...
 

·
Registered
Joined
·
722 Posts
Discussion Starter #3
the picture shows amp and bi wire, but from what you said it seems and what i was thinking is the top set should be good unless its amped
 
1 - 4 of 4 Posts
Top