AVS Forum banner
1 - 5 of 5 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter · #1 ·
I have an Onkyo 604. Should the subwoofer be receiving a signal if the signal to the receiver is Dolby 2.0 and I have the receiver set to output in one of the PLII modes? I'm watching the MHD channel in Dolby 2.0 and the sub is not working.
 

·
Registered
Joined
·
2,758 Posts
if you are using one of the PLII modes the sub should be getting a signal (if there is any sound below your xover point in the soundtrack to begin with)


whats your receiver xover set at?
 

·
Registered
Joined
·
2,758 Posts
what's the gain on the sub?


when the setting for fronts is FULL is the sub output set to both, or just mains?


perhaps you can try setting the fronts to small for a test, and see if the sub is working


if the KEFs go below 80Hz...
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top