AVS Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
139 Posts
Discussion Starter · #1 ·
hey guys,


my velodyne sub recently started popping when I would make certain adjustments on my receiver (i.e. changing sources, changing audio modes -basically anytime the audio signal is changed). Other than that, the sub works fine but I'm afraid the popping will eventually break it.


I hooked up the same sub and cable to another receiver and the popping disappeared but for some reason, there seems to be some sort of SNAFU when connected to my elite receiver. I've had the sub on both "auto" and "ON" but no luck.



The sub is a velodyne DLS-series sub..connected on the sub out on the reciever.

On the receiver, the sp settins are as follows

Front: Large

Center: Small

Rear: Large

Surround: Plus


TIA!
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top