[ncc1701d]

Anybody know anyone else than SIE (Andreas Blomberg) that is qualified to to work on Barcos? Or who knows how they work and should be repaired and serviced.


/Anders

 

[Fredrik]

You may check with Anders Olofsson / www.filmhemma.com.

Have no idea if he is qualified to service Barco's but he calibrate Barco's.

So if he doesn't do it himself he might know someone.


Any problems with SIE ?

Just so that I know because I'm going to buy a CRT and if it's poor service from them then Barco's may be out of the question.

 

[ncc1701d]

Quote:

Originally posted by Fredrik You may check with Anders Olofsson / www.filmhemma.com. Have no idea if he is qualified to service Barco's but he calibrate Barco's. So if he doesn't do it himself he might know someone. Any problems with SIE ? Just so that I know because I'm going to buy a CRT and if it's poor service from them then Barco's may be out of the question.

No problem i think. But my 1208 broke down, and made a horrible burnin in the blue tube (which was a new VDC tube 1 week old). Really bad luck.


And Andreas on SIE does not repair with "refurbished" tubes. He say he can't give guarantees after it.


And i don't think my insurance company länsfösäkringar is willing to pay 20-30000:- kr. A used neckboard and a VDC tube is only around 15000:- which they think is ok.

 

[Fredrik]

You have the PJ insured ?

Didn't know you could do it


Too bad about the tube.

Do you need a guarantee (or is that for the insurance company) ?

Otherwise you could tell SIE that he doesn't have to guarantee that the tube works as long as he does the job.

On the other hand if the PJ is insured why doesn't LF want to pay for the "real" parts ?

Or is it because it was a VDC tube from the beginning ?


How would they know if it's a VDC or not ?

 

[ncc1701d]

Tar det på svenska istället


Nej den är inte försäkrnad, men allriskförsäkringen eller "drulle" täcker rätt mycket faktiskt.


Jag vill alltså själv ha en fösräkring på att grejjorna kommer att funka ett tag efter rep.

Det kortet som sitter i har varit reparerat en gång innan (kan se det på att det är lödat på det)

Och eftersom bränningen är PRECIS likadan som i det gamla röret så har det ju uppenbarligen varit samma fel på det innan. Och jag vill inte riskera det en gång till. Därför ett nytt eller annat begagnat kort.

Och det är ju större chans att försäkringsbolaget betalar om det blir mycket billigare med ett VDC rör. Och jag bryr mig inte, bara jag får bild i den. Men röret skall vara nytt eftersom dom andra 2 är bytade precis innan jag köpte den.


SIE vill ha 10000:- för ett utbytes kort (ej nytt) och jag har fått tag på ett i USA för 2000:-. Viss skillnad ju.

 

[Fredrik]

Japp, 2000 låter bättre


Sorry guys for the swedish in all this.