AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

· Registered
Joined
·
199 Posts
Discussion Starter · #1 ·
My ECP 4500 plays just fine at 960 x 540. The other day, I tried setting up another memory with 1280 x 720p with my htpc as a source. I converged everything but when I returned to my desktop, everything was out of whack. I am pluggeg in the H synch using composite. Doesn't this pj accept this resolution? What am I doing wrong?

Don
 

· Registered
Joined
·
199 Posts
Discussion Starter · #3 ·
I am using my htpc with powerstrip. I am using a bnc connector and combining h and v. I though this was composite sync when h and v were combined! I did not check my display properties on my Ati. Thank's Clarence. Will give it another shot. BTW last time I checked the box labeled composite, my pj reported 120Hz refresh rate. This was a while back and I can't remember if I checked it in Powerstrip or my Ati.

Don
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top