AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
78 Posts
Discussion Starter · #1 ·
I am quite pleased with myself.... My Red CRT which had failed to turn on is on again. I took the focus board out and found that my G2 control wasn't funtioning... i turned it back and forth a few times and got the required resistance fluctuations. Unfotunately, the internal test pattern is not showing up clearly... I'm convinced this problem is on the neck board...I am going to swap it with the blue tomorrow to see if this corrects the problem.


I want to personally thank Curt for his advice and honesty. I had emailed him to purchase a new focus board and he said I probably didn't need one, since the circuits are in parallel and the problem is probably simply a bad solder joint. He could have sold me a board but instead walked me through the repair! Thanks Curt!
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top