AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
197 Posts
Discussion Starter · #1 ·
I used powestrip to change the refresh rate to 48hz (47.953), but when I switch to that resolution theatertek doesn't want to play @ 1280x720 @ 48hz. (The desktop shows fine and I can reopen powerstip and verify that it is using the custom timings at 47.953)


The sound begins like the movie is starting but there is no picture. I bring up the general configuration tab in theatertek and it says the resolution is still 1280x720 @ 60, so I assume that is the problem.


How do I get theatertek to recognize the resolution has been changed?


also, if anyone has their HTPC running at this resolution would you mind sharing your timings, so I can verify that mine are at least similar to yours and then eliminate that as being a possible problem.


thanks
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top