Get an exclusive sneak peek into our new project. >>> Click Here

Toshiba MT8 3.7 software

359 Views 4 Replies 3 Participants Last post by mark antony, May 31, 2004

mark antony

Discussion Starter · May 27, 2004

Hi

Does anyone know if the version 3.7 software available for the Infocus 7200 is as yet available in Toshiba form, with the Toshiba start-up screen.

I realise the infocus software works with the MT 8, but my machine has gone back for repair 4 times in the past year, and so it's not worth the trouble of having to reload an older toshiba software software back on to the projector every time it goes back - and which may not produce the same faults.

Thanks

M

Save

Status: Not open for further replies.

1 - 5 of 5 Posts

audionut101

· #2 · May 27, 2004

M,

why did you send your unit back 4 times? I have the same unit. btw, I installed the IF3.7 and sent my unit back for the color wheel whine and they flashed 3.2 on my unit! It came with 3.5 originally. the color wheel whine is worse than when it oringally left. suposedly they changed the light engine and a few other parts, but I highly doubt it.

Save

glenned

· #3 · May 27, 2004

Quote:

Originally posted by audionut101
M,

why did you send your unit back 4 times? I have the same unit. btw, I installed the IF3.7 and sent my unit back for the color wheel whine and they flashed 3.2 on my unit! It came with 3.5 originally. the color wheel whine is worse than when it oringally left. suposedly they changed the light engine and a few other parts, but I highly doubt it.

There are two fans and one blower (on the lamp) that can make the same kind of noise as the color wheel. Your problem may be with one of them instead.

Glenn

Save

mark antony

Discussion Starter · #4 · May 27, 2004

As requested...!

The first time it went back, and was replaced, was because the power switch didn't work!

The second unit went back, and was also replaced, because it was producing a high pitched whine that was really annoying and unacceptable.

The third time the unit went back was because the picture had a "stain" on the right side that appeared after 2 months - which was cured by replacing the optic unit

and finally the forth time it wernt back was because the bulb failed after only 1000 hours use, when it's supposed to last 2-3K hours so I demanded they replaced it - and they did.

Mark

See less See more

Save

mark antony

Discussion Starter · #5 · May 31, 2004

anyone?

M

Save

1 - 5 of 5 Posts

Status: Not open for further replies.

Top Contributors this Month