AVS Forum banner
Status
Not open for further replies.
1 - 7 of 7 Posts

·
Registered
Joined
·
251 Posts
Discussion Starter · #1 ·
Well, I just finished sticking a nice looking tube in an ECP Graphics, and man what a pain that was! I had to move so much of the guts of the projector to accomodate for the removal and re-assembly of that tube, that I almost gave up several times.


Anyhoo, I got thinking as I was putting this back together, and I've got a question for those of you that are familiar with the internals of the ECP graphics (Curt? Bruce? others).


Since the specs of the ECP graphics are very similar to the EXP 3xxx and 4xxx line up, is it possible to transplant the internals of the ECP Graphics (tubes, and all the boards) into a empty shell of an ECP 3/4xxx?
 

·
Registered
Joined
·
251 Posts
Discussion Starter · #2 ·
Nobody's got any ideas?
 

·
Registered
Joined
·
18,503 Posts
I've never seen the Graphics version of this set, sorry!


Curt
 

·
Registered
Joined
·
295 Posts
Why put the guts of a grphics into a 4000?

I thought the graphics was a better projector.


I've never seen one either. Curt has not seen a projector ??? Whats going on!?!
 

·
Registered
Joined
·
2,458 Posts
Quote:
Originally Posted by MrGogo
Why put the guts of a grphics into a 4000?

I thought the graphics was a better projector.


I've never seen one either. Curt has not seen a projector ??? Whats going on!?!
You probably meant to say "Curt does'nt have four under the kitchen table, two or three more in closets, and another on the bench?" :D
 

·
Registered
Joined
·
18,503 Posts
Nope, never seen that one, an ECP 2100 or 2500. Got multiples of everything else..;)


Curt
 

·
Registered
Joined
·
2,458 Posts
Curt, please check your PMs.
 
1 - 7 of 7 Posts
Status
Not open for further replies.
Top