AVS Forum banner
Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
13,771 Posts
Discussion Starter · #1 ·
I have two receivers in my living room right now. A DISH 5000 and a DISH 6000. Is there any way to set them up so that I can control one with one remote and the other with another remote? Right now if I am recording with the 5000, I cannot play around with the 6000, other than using the receiver itself.
 

·
Banned
Joined
·
4,999 Posts
Look in the manual. You can change the codes for each receiver by assigning a different number (1 to 15, I think) for the remote and the receiver. By having a different number for the paired remote/receiver, you can independently control each one without interferring with the other. The manual will describe the method to accompish this.
 

·
Registered
Joined
·
13,771 Posts
Discussion Starter · #3 ·
I must have looked right over that section when I went through the manual. I'll check that out tonight. Thanks.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top