AVS Forum banner
Status
Not open for further replies.
1 - 1 of 1 Posts

·
Registered
Joined
·
2,674 Posts
Discussion Starter · #1 ·
I need to get my projector up on the ceiling to play with the screen I've ordered, which ends up where I want it if I either drop my projector 5" or hang it at a 2 degree angle (this is within Sony's throw angle limits). I prefer the later (8' ceiling, 16" projector, a few inches for hush box clearance, a few more for insulation) Has any one done this?


Various thoughts along these lines are


- Rubber washers. I want more rigidity.


- A cone or ball shaped surface (like a bicycle cone nut or push-rod V8 rocker ball) which will be self-centering inin a mounting hole, tolerate mis-alignment, and allow for rigid clamping.
 
1 - 1 of 1 Posts
Status
Not open for further replies.
Top