AVS Forum banner

Status
Not open for further replies.
1 - 3 of 3 Posts

·
Registered
Joined
·
26 Posts
Discussion Starter #1
I just got comcast cable installed and I'm having a little problem getting SageTV to reliably change the channel through the USB-UIRT. Sometimes it works, but only about half the time. Most of the time it fails is because the USB-UIRT is sending the codes too slow for the Motorola 5100 box. The box will get 1 or 2 then reset and recieve the rest, but since it isn't a complete entry, it just resets.


Is there any way to make the USB-UIRT send the codes faster?


Thanks
 

·
Registered
Joined
·
3,792 Posts
Did you try to tune it up in the "Settings" dialog ? There are quite a few settings, including "Speed".
 

·
Registered
Joined
·
142 Posts
There are settings in Sage that adjust the delay between commands. For my scientific atlanta box i turned down the delay to 100ms and got significantly faster channel changes.
 
1 - 3 of 3 Posts
Status
Not open for further replies.
Top