AVS Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
303 Posts
Discussion Starter · #1 ·
I'm adding a 2nd sub to be driven by my EP2500...


I want to verify some basics....


Here's my current setup (1 sub)

http://akamaipix.crutchfield.com/ca/..._8-ohm_2ch.jpg


Scott (ficaraudio) confirmed that this should be my wiring with the 2nd sub added...

http://akamaipix.crutchfield.com/ca/..._8-ohm_2ch.jpg


Question: At the amp...I am currently in "bridged mode" with wires running to the 2 Red (inner) connections...


With the second one added...does the amp connection change at all"? Dont think so but just want to verify...


thanks

Matt
 

·
Registered
Joined
·
810 Posts
Your amp connection will stay the same. You are going from a single 8 ohm driver to 2 8 ohm drivers to give the amp a 4 ohm load .
 

·
Registered
Joined
·
303 Posts
Discussion Starter · #3 ·

Quote:
Originally Posted by Rightbrained /forum/post/15582083


Your amp connection will stay the same. You are going from a single 8 ohm driver to 2 8 ohm drivers to give the amp a 4 ohm load .

yep...that sounds right... thank you
 

·
Registered
Joined
·
810 Posts
No problem at all . Good luck with your build.
 
1 - 4 of 4 Posts
Top